Installing Option Cards - Bay Networks 2000 Getting Started Manual

Installing Option Cards

The following illustration shows you how install LAN or WAN option cards into the
Switch. You can use Slots 1 to 3 for any mix of LAN and WAN cards. Note that Slot 4
is not supported.
1. Power off the Switch.
2. Remove the filler panel screw and pull out the filler panel.
3. Slide the option card into the intended slot. Make sure the card seats
firmly and evenly into the card slot. If the card is not seated properly,
it will not work.
44
Figure 19 Installing LAN or WAN Cards
Changing Hardware Configurations