Figure 113. Installing the front cover
3. Hold the front door at an approximate 120 degree angle to the system as shown in the following
figure. Engage the latches.
Figure 114. Installing the front door
Removing the service access cover from a rack-mounted 8202-E4B,
8202-E4C, 8202-E4D, 8205-E6B, 8205-E6C, or 8205-E6D system
Use this procedure to remove the service access cover.
1. Loosen the two thumbscrews (A) located at the rear of the cover.
2. Slide the cover toward the rear of the system unit. When the front of the service access cover has
cleared the upper frame ledge, lift the cover up and off the system unit.
Common procedures for installable features
155