Removing A Solid-State Drive From The Edr1 Pcie Storage Enclosure; Removing A Disk Drive By Using The Hot-Spare Function In An Ibm I System Or Logical Partition From 8202-E4B, 8202-E4C, 8202-E4D, 8205-E6B, 8205-E6C, Or 8205-E6D - IBM 8202-E4B Manual

5. Grasp the handle (C) and pull the drive partially out of the slot.
6. Grasp the solid-state drive and pull it out from the slot.
7. Press Enter on the console to indicate that you have removed the solid-state drive.
Figure 34. Removing the solid-state drive from the EDR1 PCIe storage enclosure
If you are installing a replacement solid-state drive, proceed to the procedure for replacing the solid-state
drive in the EDR1 PCIe storage enclosure. For instructions, see "Replacing a solid-state drive in the EDR1
PCIe storage enclosure" on page 75.
If you are not installing a replacement solid-state drive, install a filler in the empty slot to ensure proper
air flow for cooling. For instructions, see "Installing a disk drive filler in the 8202-E4B, 8202-E4C,
8202-E4D, 8205-E6B, 8205-E6C, or 8205-E6D" on page 93.
Removing a disk drive by using the hot-spare function in an IBM i
system or logical partition from 8202-E4B, 8202-E4C, 8202-E4D,
8205-E6B, 8205-E6C, or 8205-E6D
You can use the hot-spare function to replace a disk drive in a system or expansion unit while the IBM i
operating system or logical partition that controls the disk drive location is powered-on.
Complete the following tasks to remove a drive:
v "Preparing the system" on page 53
v "Preparing to remove a disk drive by using the HSM" on page 53
v Select from the following options:
– "Removing the disk drive or solid-state drive from the 8202-E4B, 8202-E4C, 8202-E4D, 8205-E6B,
8205-E6C, or 8205-E6D system or expansion unit" on page 55
– "Removing a solid-state drive from the EDR1 PCIe storage enclosure" on page 56 (This drive
enclosure is supported for the 8202-E4D and 8205-E6D systems.)
52
Disk drives or solid-state drives