Figure 54. Replacing a solid-state drive in the 5888 PCIe storage enclosure.
Proceed to the procedure for completing the drive replacement. For instructions, see "Completing the
procedure" on page 84.
Replacing a solid-state drive in the EDR1 PCIe storage enclosure
Complete the following steps to replace a solid-state drive in the EDR1 PCIe storage enclosure.
1. With the handle in the unlocked position, align the solid-state drive with the guide rails in the
enclosure.
Note: Do not hold the drive only by the handle. Support the drive by holding the drive by its sides.
2. Slide the solid-state drive into the EDR1 PCIe storage enclosure until the drive stops.
3. Rotate the handle (A) to the locked position, as shown in Figure 55 on page 84.
4. Install the bezel (B).
Disk drives or solid-state drives
83