Figure 109. Front cover on a model 7314-G30 or 5796
3. Press the cover onto the chassis and release the latches. The cover securely snaps into place.
4. Replace the two thumbscrews (B) into the slots on the left and right of the front cover.
Removing and replacing covers for the 8202-E4B, 8202-E4C, 8202-E4D,
8205-E6B, 8205-E6C, or 8205-E6D
Use these instructions to remove, replace, or install covers so that you can access the hardware parts or
perform service.
Removing the front cover from a rack-mounted system
Use this procedure to remove the cover to access components or perform service.
To remove the front cover, follow these steps:
1. Remove the two shipping screws (if present) that secure the system to the rack.
Note: Replacing the shipping screws is optional but should be done in geographic areas that are
prone to seismic activity.
2. Pull the cover away from the system. The cover has an indentation where you can hold onto it more
easily.
Common procedures for installable features
151