Removing A Solid-State Drive From The 5888 Pcie Storage Enclosure - IBM 8202-E4B Manual

6. Grasp the handle (C) and pull the drive partially out of the slot.
7. Grasp the solid-state drive and pull it out from the slot.
8. Press Enter on the console to indicate that you have removed the solid-state drive.
Figure 21. Removing the solid-state drive from the 5888 PCIe storage enclosure
If you are installing a replacement solid-state drive, proceed to the procedure for replacing the solid-state
drive in the 5888 PCIe storage enclosure. For instructions, see "Replacing a solid-state drive in the 5888
PCIe storage enclosure" on page 65.
If you are not installing a replacement solid-state drive, install a filler in the empty slot to ensure proper
air flow for cooling. For instructions, see "Installing a disk drive filler in the 8202-E4B, 8202-E4C,
8202-E4D, 8205-E6B, 8205-E6C, or 8205-E6D" on page 93.
Removing a solid-state drive from the EDR1 PCIe storage enclosure
Complete the following steps to remove a solid-state drive from the EDR1 PCIe storage enclosure.
1. Select Replace/Remove a Device Attached to an SCSI Hot Swap Enclosure Device.
2. Select the solid-state drive that you want to remove. To view the locations of the service indicators, go
to "Solid-state drive locations and service indicators for the EDR1 PCIe storage enclosure" on page
106.
3. Press Enter.
4. Pull off the bezel (A) that covers the slot that contains the solid-state drive.
5. When the solid-state drive identify LED turns on solid, slide the release latch (B) over gently to
unlock the drive handle. See Figure 22 on page 37.
6. Grasp the handle (C) and pull the drive partially out of the slot.
7. Grasp the solid-state drive and pull it out from the slot.
8. Press Enter on the console to indicate that you have removed the solid-state drive.
36
Disk drives or solid-state drives