Installing A Solid-State Drive In The 5888 Pcie Storage Enclosure - IBM 8202-E4B Manual

Figure 3. Installing a solid-state drive in the 5888 PCIe storage enclosure
7. On the console, press Enter to indicate that you have installed the drive.
Proceed to the procedure for completing the disk drive or solid-state drive installation. For instructions,
go to "Completing the disk drive or solid-state drive installation by using the diagnostic command" on
page 11.
Installing a solid-state drive in the EDR1 PCIe storage enclosure
Complete the following steps to install a solid-state drive in the EDR1 PCIe storage enclosure:
1. With the handle in the unlocked position, align the solid-state drive with the guide rails in the
enclosure. See Figure 4 on page 11.
Note: Do not hold the solid-state drive only by the handle. Support the drive by holding the drive by
its sides.
2. Slide the drive halfway into the EDR1 PCIe storage enclosure.
3. Select the drive that you want to install and press Enter on the console.
4. When the identify LED turns on solid, slide the solid-state drive into the EDR1 PCIe storage enclosure
until the drive stops.
Important: When installing a drive, ensure that the drive is fully seated and is all the way into the
EDR1 PCIe storage enclosure.
5. Rotate the handle (A) to the locked position.
6. Install the bezel (B).
10
Disk drives or solid-state drives