Installing A Solid-State Drive In The 5888 Pcie Storage Enclosure - IBM 8202-E4B Manual

Figure 8. Installing a solid-state drive in the 5888 PCIe storage enclosure
Proceed to the procedure for verifying the drive installation. For instructions, go to "Verifying that the
new disk drive or solid-state drive is installed and operational" on page 18.
Installing a solid-state drive in the EDR1 PCIe storage enclosure
Complete the following steps to install a solid-state drive in the EDR1 PCIe storage enclosure:
1. With the handle in the unlocked position, align the solid-state drive with the guide rails in the
enclosure. See Figure 9 on page 18.
Note: Do not hold the solid-state drive only by the handle. Support the drive by holding the drive by
its sides.
2. Slide the drive halfway into the EDR1 PCIe storage enclosure.
3. On the Verify Device Concurrent Add display, verify that the selected drive is the drive you want to
replace, then press Enter.
4. When the identify LED flashes, slide the solid-state drive into the EDR1 PCIe storage enclosure until
the drive stops.
Important: When installing a drive, ensure that the drive is fully seated and is all the way into the
EDR1 PCIe storage enclosure.
5. Rotate the handle (A) to the locked position.
6. Install the bezel (B).
Disk drives or solid-state drives
17