Removing Or Installing A Disk Drive Bezel; Removing A Disk Drive Bezel From A Drive Or Filler For The 8202-E4B, 8202-E4C, 8202-E4D, 8205-E6B, 8205-E6C, Or 8205-E6D - IBM 8202-E4B Manual

Attention:
v Attach a wrist strap to an unpainted metal surface of your hardware to prevent electrostatic
discharge (ESD) from damaging your hardware.
v When using a wrist strap, follow all electrical safety procedures. A wrist strap is for static control. It
does not increase or decrease your risk of receiving electric shock when using or working on
electrical equipment.
v If you do not have a wrist strap, just prior to removing the product from ESD packaging and
installing or replacing hardware, touch an unpainted metal surface of the system for a minimum of
5 seconds.
2. Slide the disk drive filler all the way into the system or expansion unit, and push the disk drive filler
handle (A) until it locks, as shown in Figure 60.
Figure 60. Installing a disk drive filler in the system
Return to the procedure that brought you here.

Removing or installing a disk drive bezel

Learn how to remove or install the disk drive bezel from and into a disk drive.
Removing a disk drive bezel from a drive or filler for the 8202-E4B,
8202-E4C, 8202-E4D, 8205-E6B, 8205-E6C, or 8205-E6D
Learn how to remove a disk drive bezel from a drive or a disk drive filler.
Learn to remove the disk-drive bezel from either a failed drive that had a bezel installed in it or from the
disk drive filler in the slot where you are replacing the failed drive. The removed disk-drive bezel must
be attached in the replacement disk drive or a disk drive filler before installing the drive or filler in the
system or expansion unit. To install a disk drive filler, see "Installing a disk drive bezel in a drive or filler
for the 8202-E4B, 8202-E4C, 8202-E4D, 8205-E6B, 8205-E6C, or 8205-E6D" on page 95. Complete the steps
in this procedure only if the drive or the disk drive filler has a disk-drive bezel attached to it.
94
Disk drives or solid-state drives