Installing A Solid-State Drive In The Edr1 Pcie Storage Enclosure; Completing The Disk Drive Or Solid-State Drive Installation; Completing The Procedure - IBM 8202-E4B Manual

Important: When installing a drive, ensure that the drive is fully seated and is all the way into the
EDR1 PCIe storage enclosure.
5. Rotate the handle (A) to the locked position.
6. Install the bezel (B).
Figure 15. Installing a solid-state drive in the EDR1 PCIe storage enclosure
Proceed to the procedure for completing the disk drive or solid-state drive installation. For instructions,
go to "Completing the disk drive or solid-state drive installation."

Completing the disk drive or solid-state drive installation

1. Return to the console and wait until the Concurrent Maintenance Results display is shown, and then
press Enter.
2. When the HSM display is shown, press F12 twice and then press Enter.
Proceed to completing the procedure.

Completing the procedure

Complete the following steps after you install or replace the disk drive or solid-state drive in a system,
enclosure, or expansion unit:
1. Replace the front cover:
v For instructions for a rack-mounted system, see "Installing the front cover on a rack-mounted
8202-E4B, 8202-E4C, 8202-E4D, 8205-E6B, 8205-E6C, or 8205-E6D system" on page 153.
v For instructions for a stand-alone system, see "Installing the front cover and front door on a
stand-alone 8202-E4B, 8202-E4C, 8202-E4D, or 8205-E6B system" on page 154.
2. Verify the installed part:
v If you replaced the part because of a failure, verify the installed part. For instructions, see
"Verifying a repair" on page 177.
v If you installed the part for any other reason, verify the installed part. For instructions, see
"Verifying the installed part" on page 165.
Disk drives or solid-state drives
25