Replacing A Solid-State Drive In The Edr1 Pcie Storage Enclosure; Completing The Disk Drive Or Solid-State Drive Replacement By Using The Hsm; Completing The Procedure - IBM 8202-E4B Manual

Figure 50. Replacing a solid-state drive in the EDR1 PCIe storage enclosure.
Proceed to the procedure for completing the drive replacement. For instructions, see "Completing the
disk drive or solid-state drive replacement by using the HSM."

Completing the disk drive or solid-state drive replacement by using the HSM

Complete the following task to complete the disk drive or solid-state drive replacement:
1. Return to the console and wait until the Concurrent Maintenance Results display is shown, and then
press Enter.
2. If you return to the Service Action Log display, exit the service action log.
3. When the HSM display is shown, press F3.
Proceed to completing the procedure.

Completing the procedure

Complete the following steps after you install or replace the disk drive or solid-state drive in a system,
enclosure, or expansion unit:
1. Replace the front cover:
v For instructions for a rack-mounted system, see "Installing the front cover on a rack-mounted
8202-E4B, 8202-E4C, 8202-E4D, 8205-E6B, 8205-E6C, or 8205-E6D system" on page 153.
v For instructions for a stand-alone system, see "Installing the front cover and front door on a
stand-alone 8202-E4B, 8202-E4C, 8202-E4D, or 8205-E6B system" on page 154.
2. Verify the installed part:
v If you replaced the part because of a failure, verify the installed part. For instructions, see
"Verifying a repair" on page 177.
v If you installed the part for any other reason, verify the installed part. For instructions, see
"Verifying the installed part" on page 165.
76
Disk drives or solid-state drives