Installing A Solid-State Drive In The Edr1 Pcie Storage Enclosure; Completing The Disk Drive Or Solid-State Drive Installation By Using The Diagnostic Command; Completing The Procedure - IBM 8202-E4B Manual

Figure 4. Installing a solid-state drive in the EDR1 PCIe storage enclosure
7. On the console, press Enter to indicate that you have installed the drive.
Proceed to the procedure for completing the disk drive or solid-state drive installation. For instructions,
go to "Completing the disk drive or solid-state drive installation by using the diagnostic command."
Completing the disk drive or solid-state drive installation by using the diagnostic
command
Complete the following steps after you install or replace the disk drive or solid-state drive in a system or
in an expansion unit:
1. Complete the following steps by using the diagnostic command:
a. Press Enter.
b. Exit to the command line.
c. If you are installing more than one disk drive or solid-state drive, repeat this procedure until all
disk drives or solid-state drives are installed.
d. Press Cancel. The SCSI and SCSI RAID Hot Plug Manager menu is displayed.
e. Select Configure Added/Replaced Devices.
2. Proceed to completing the procedure.

Completing the procedure

Complete the following steps after you install or replace the disk drive or solid-state drive in a system,
enclosure, or expansion unit:
1. Replace the front cover:
v For instructions for a rack-mounted system, see "Installing the front cover on a rack-mounted
8202-E4B, 8202-E4C, 8202-E4D, 8205-E6B, 8205-E6C, or 8205-E6D system" on page 153.
v For instructions for a stand-alone system, see "Installing the front cover and front door on a
stand-alone 8202-E4B, 8202-E4C, 8202-E4D, or 8205-E6B system" on page 154.
2. Verify the installed part:
Disk drives or solid-state drives
11