Preparing To Replace A Disk Drive Or Solid-State Drive By Using The Diagnostic Command; Replacing A Disk Drive Or Solid-State Drive In The 8202-E4B, 8202-E4C, 8202-E4D, 8205-E6B, 8205-E6C, Or 8205-E6D System Or Expansion Unit - IBM 8202-E4B Manual

Preparing to replace a disk drive or solid-state drive by using the diagnostic
command
Complete the following steps before you replace a disk drive or solid-state drive by using the diagnostic
command:
1. If you are already on the SCSI and SCSI RAID Hot Plug Manager display, go to 10.
2. Log in as root user.
3. At the command line, type diag and press Enter.
4. On the Diagnostic Operating Instructions display, press Enter to continue.
5. On the Function Selection display, select Task Selection.
6. Select RAID Array Manager.
7. Depending on the adapter that your drive is attached to, select IBM SAS Disk Array Manager, PCI
SCSI Disk Array Manager, or PCI-X SCSI Disk Array Manager.
8. Select Diagnostics and Recovery Options.
9. Select SCSI and SCSI RAID Hot Plug Manager.
10. Select Attach a Device to an SCSI Hot Swap Enclosure Device.
Choose from the following options:
v If you are replacing a drive in a system or expansion unit, proceed to "Replacing a disk drive or
solid-state drive in the 8202-E4B, 8202-E4C, 8202-E4D, 8205-E6B, 8205-E6C, or 8205-E6D system or
expansion unit."
v If you are replacing a drive in the 5888 PCIe storage enclosure, proceed to "Replacing a solid-state
drive in the 5888 PCIe storage enclosure" on page 65.
v If you are replacing a drive in the EDR1 PCIe storage enclosure, proceed to "Replacing a solid-state
drive in the EDR1 PCIe storage enclosure" on page 66.
Replacing a disk drive or solid-state drive in the 8202-E4B, 8202-E4C, 8202-E4D,
8205-E6B, 8205-E6C, or 8205-E6D system or expansion unit
Complete the following steps to replace a disk drive or solid-state drive in a system or in an expansion
unit:
1. If the drive you are installing does not have a bezel preinstalled, then complete the tasks to install a
bezel on the drive, then continue with this procedure from step 3. For instructions to install a bezel,
see "Installing a disk drive bezel in a drive or filler for the 8202-E4B, 8202-E4C, 8202-E4D, 8205-E6B,
8205-E6C, or 8205-E6D" on page 95.
2. If the drive you are installing has a bezel preinstalled, then go to step 3.
3. Unlock the drive handle by squeezing it and pulling it out toward you. If the handle is not all the
way out, the disk drive or solid-state drive does not slide into the system or an expansion unit.
4. Hold the disk drive or solid-state drive by the top and bottom edges as you position the drive, and
insert it into the system or the expansion unit. Do not hold the disk drive or solid-state drive by the
handle.
5. Slide the disk drive or solid-state drive halfway into the system or an expansion unit.
6. On the Verify Device Concurrent Add display, verify that the selected drive is the drive you want to
replace, and then press Enter.
7. When the identify LED turns on solid, slide the disk drive or solid-state drive all the way into the
system or an expansion unit, and push the drive handle (A) in until it locks, as shown in Figure 42 on
page 65.
64
Disk drives or solid-state drives