IBM 8202-E4B Manual page 43

4. Record the position where the new disk drive or solid-state drive must be installed. For example, the
next available disk drive or solid-state drive slot might be P3-D4.
5. If applicable, remove the system unit door, remove the expansion unit door, or open the rack.
6. Stop the system or logical partition. For instructions, see "Stopping a system or logical partition" on
page 147.
7. Remove the front cover:
v For instructions for a rack-mounted system, see "Removing the front cover from a rack-mounted
system" on page 151.
v For instructions for a stand-alone system, see "Removing the front cover from a stand-alone
8202-E4B, 8202-E4C, 8202-E4D, or 8205-E6B system" on page 152.
8. Disconnect the power source from the system by unplugging the system. For instructions, see
"Disconnecting the power cords from the 8202-E4B, 8202-E4C, 8202-E4D, 8205-E6B, 8205-E6C, or
8205-E6D system" on page 163
Note: This system might be equipped with a second power supply. Disconnect it before continuing
with this procedure. Ensure that the power source to the system has been completely disconnected.
(L003)
or
9. Attach a wrist strap.
Disk drives or solid-state drives
27