Removing A Sas Conduit Card From A 5802 Expansion Unit With The Power Turned Off - IBM 8202-E4B Manual

17. Replace all expander cards and fillers, if you had removed them earlier.
a. Supporting the bottom of the expander card with your hand, align it with the guide rails in the
backplane.
b. Slide the expander card all the way into the backplane.
c. Push the handle (A) toward the card to lock it into place.
18. Start the system. For instructions, see Starting the system or logical partition.
Continue with any other service actions you are required to complete.
v For information about connecting the system, see Connecting the expansion units.
v For information about installing the PCI adapters into the system board, see Model 5802 and 5877
expansion units, PCI adapters, and cassettes.
Removing a SAS conduit card from a 5802 expansion unit with the
power turned off
Learn how to remove a SAS conduit card from a 5802 rack-mounted expansion unit if you must replace a
failing part with the power turned off.
Complete the following steps to remove a SAS conduit card from a 5802 rack-mounted expansion unit:
1. Complete the prerequisite tasks. For instructions, see "Before you begin" on page 137.
2. Identify the card you want to remove. For information, see "Identifying a part" on page 139.
3. Stop the system or logical partition. For instructions, see "Stopping a system or logical partition" on
page 147.
4. Remove the drives and fillers as shown in Figure 94 on page 127.
a. Squeeze the latch of the drive and pull the handle (A) toward you to release the drive.
b. Support the bottom of the drive with your hand and slide the drive out of the backplane.
126
Disk drives or solid-state drives