IBM 8202-E4B Manual page 76

Figure 39. Removing a disk drive from the system
3. If the removed drive has a bezel attached to it, you can remove the disk drive bezel. For instructions,
see "Removing a disk drive bezel from a drive or filler for the 8202-E4B, 8202-E4C, 8202-E4D,
8205-E6B, 8205-E6C, or 8205-E6D" on page 94.
Important: If the disk drive bezel does not have a thumbscrew, then the bezel is not removable and
the drive is a SAS disk drive. The replacement SAS disk drive comes with a preinstalled bezel.
If you are installing a replacement drive as a replacement for the failed disk drive or solid-state drive, go
to "Replacing a disk drive or solid-state drive in the 8202-E4B, 8202-E4C, 8202-E4D, 8205-E6B, 8205-E6C,
or 8205-E6D with the system or logical partition power turned off" on page 81.
If you are not installing a replacement drive, install a filler in the empty slot to ensure proper air flow for
cooling. For instructions, see "Installing a disk drive filler in the 8202-E4B, 8202-E4C, 8202-E4D, 8205-E6B,
8205-E6C, or 8205-E6D" on page 93.
Removing a solid-state drive from the 5888 PCIe storage enclosure
Complete the following steps to remove a solid-state drive from the 5888 PCIe storage enclosure.
1. Pull off the bezel (A) that covers the slot that contains the solid-state drive. See Figure 40 on page 61.
2. Slide the release latch (B) over gently to unlock the drive handle.
3. Grasp the handle (C) and pull the drive partially out of the slot.
60
Disk drives or solid-state drives