Replacing A Solid-State Drive In The Edr1 Pcie Storage Enclosure; Completing The Disk Drive Or Solid-State Drive Replacement By Using The Iprconfig Command; Completing The Procedure - IBM 8202-E4B Manual

Figure 48. Replacing a solid-state drive in the EDR1 PCIe storage enclosure.
Proceed to the procedure for completing the drive replacement. For instructions, see "Completing the
disk drive or solid-state drive replacement by using the iprconfig command."
Completing the disk drive or solid-state drive replacement by using the iprconfig
command
Complete the following steps by using the iprconfig command:
1. Press Enter on the Complete Device Concurrent Add display to indicate that the disk drive or
solid-state drive is installed.
2. Proceed to completing the procedure.

Completing the procedure

Complete the following steps after you install or replace the disk drive or solid-state drive in a system,
enclosure, or expansion unit:
1. Replace the front cover:
v For instructions for a rack-mounted system, see "Installing the front cover on a rack-mounted
8202-E4B, 8202-E4C, 8202-E4D, 8205-E6B, 8205-E6C, or 8205-E6D system" on page 153.
v For instructions for a stand-alone system, see "Installing the front cover and front door on a
stand-alone 8202-E4B, 8202-E4C, 8202-E4D, or 8205-E6B system" on page 154.
2. Verify the installed part:
v If you replaced the part because of a failure, verify the installed part. For instructions, see
"Verifying a repair" on page 177.
v If you installed the part for any other reason, verify the installed part. For instructions, see
"Verifying the installed part" on page 165.
3. To rebuild data on the newly installed or replaced disk drive or solid-state drive, see "Rebuilding data
on a replacement disk drive or solid-state drive in a system or logical partition running Linux" on
page 111.
72
Disk drives or solid-state drives