IBM 8202-E4B Manual page 105

v To remove the service access cover for a stand-alone system, see "Removing the service access
cover from a stand-alone 8202-E4B, 8202-E4C, 8202-E4D, or 8205-E6B system" on page 156.
9. Disconnect all PCI adapters that are connected to the system. For instructions, see Removing a PCI
adapter.
10. If you are installing into a new system, remove the filler from the external SAS connection port on
the disk drive backplane.
11. Insert the standoff into the SAS cable.
12. Connect the SAS shroud of the SAS cable (A) to the external SAS connection port on the system
backplane, at the rear of the system, until it snaps in place, as shown in Figure 57.
13. Lay the cable beside the side wall, and slide the cable through the centre brace (B), towards the SAS
connection port on the disk drive backplane.
14. Push the SAS shroud (D) into the SAS connection port on the disk drive backplane until it snaps in
place.
Figure 57. Installing the external SAS port
15. Replace the tape drive if you removed it.
16. Replace all PCI adapters. For instructions, See Replacing a PCI adapter.
17. Replace the service access cover:
v For a rack-mounted system, see "Installing the service access cover on a rack-mounted 8202-E4B,
8202-E4C, 8202-E4D, 8205-E6B, 8205-E6C, or 8205-E6D system" on page 158.
v For a stand-alone system, see "Installing the service access cover on a stand-alone 8202-E4B,
8202-E4C, 8202-E4D, or 8205-E6B system" on page 158.
18. For a rack-mounted system, place the system into the operating position. For instructions, see
"Placing the rack-mounted 8202-E4B, 8202-E4C, 8202-E4D, 8205-E6B, 8205-E6C, or 8205-E6D system
into the operating position" on page 161.
19. Replace the front cover:
Disk drives or solid-state drives
89