Removing A Solid-State Drive From The Edr1 Pcie Storage Enclosure; Removing The Disk Drive In The 8202-E4B, 8202-E4C, 8202-E4D, 8205-E6B, 8205-E6C, Or 8205-E6D With The Linux System Or Logical Partition Power Turned On - IBM 8202-E4B Manual

Figure 22. Removing the solid-state drive from the EDR1 PCIe storage enclosure
If you are installing a replacement solid-state drive, proceed to the procedure for replacing the solid-state
drive in the EDR1 PCIe storage enclosure. For instructions, see "Replacing a solid-state drive in the EDR1
PCIe storage enclosure" on page 66.
If you are not installing a replacement solid-state drive, install a filler in the empty slot to ensure proper
air flow for cooling. For instructions, see "Installing a disk drive filler in the 8202-E4B, 8202-E4C,
8202-E4D, 8205-E6B, 8205-E6C, or 8205-E6D" on page 93.
Removing the disk drive in the 8202-E4B, 8202-E4C, 8202-E4D,
8205-E6B, 8205-E6C, or 8205-E6D with the Linux system or logical
partition power turned on
Learn how to remove a disk drive or solid-state drive from a system or expansion unit with the Linux
operating system or logical partition that controls the drive location is powered on.
Attention: Review the following information to determine if your situation requires for a different
procedure to be performed instead of this one:
v Go to "Removing a disk drive or solid-state drive from the 8202-E4B, 8202-E4C, 8202-E4D, 8205-E6B,
8205-E6C, or 8205-E6D with the system or logical partition power turned off" on page 57 if you do not
feel comfortable using the procedure with the power turned on.
v If you are installing a new or upgraded drive, see "Installing a disk drive or solid-state drive in the
8202-E4B, 8202-E4C, 8202-E4D, 8205-E6B, 8205-E6C, or 8205-E6D with the Linux system or logical
partition power turned on" on page 12.
If the system or logical partition that controls the drive you are replacing is at the Linux command line,
you can use this powered-on procedure.
If you are removing a drive as part of a service procedure, continue to use the following procedure.
Disk drives or solid-state drives
37