Installing A Solid-State Drive In The 5888 Pcie Storage Enclosure - IBM 8202-E4B Manual

Figure 18. Installing a solid-state drive in the 5888 PCIe storage enclosure
Proceed to the procedure for completing the disk drive or solid-state drive installation. For instructions,
go to "Completing the procedure" on page 32.
Installing a solid-state drive in the EDR1 PCIe storage enclosure
Complete the following steps to install a solid-state drive in the EDR1 PCIe storage enclosure:
1. With the handle in the unlocked position, align the solid-state drive with the guide rails in the
enclosure. See Figure 19 on page 32,
Note: Do not hold the drive only by the handle. Support the drive by holding the drive by its sides.
2. Slide the solid-state drive into the EDR1 PCIe storage enclosure until the drive stops.
3. Rotate the handle (A) to the locked position, as shown in Figure 19 on page 32.
4. Install the bezel (B).
Disk drives or solid-state drives
31