Removing The Disk Drive Or Solid-State Drive From The 8202-E4B, 8202-E4C, 8202-E4D, 8205-E6B, 8205-E6C, Or 8205-E6D System Or Expansion Unit - IBM 8202-E4B Manual

9. Select 1 (Remove device) for the Action to be performed.
10. Set the time delay, for example, for one minute: 01.
Note: You can set an appropriate time delay of 01 - 19 minutes to allow adequate time to access the
disk drive or solid-state drive.
Important: Do not press Enter at this time.
11. Locate the service indicator that corresponds to the position of the drive that you are removing from
a system or from an expansion unit.
Choose from the following options:
v If you are removing a drive from a system or expansion unit, proceed to "Removing the disk drive or
solid-state drive from the 8202-E4B, 8202-E4C, 8202-E4D, 8205-E6B, 8205-E6C, or 8205-E6D system or
expansion unit."
v If you are removing a drive from the EDR1 PCIe storage enclosure, proceed to "Removing a solid-state
drive from the EDR1 PCIe storage enclosure" on page 51.
Removing the disk drive or solid-state drive from the 8202-E4B, 8202-E4C,
8202-E4D, 8205-E6B, 8205-E6C, or 8205-E6D system or expansion unit
Complete the following steps to remove a disk drive or solid-state drive from a system or from an
expansion unit:
1. On the system, unlock the drive handle by squeezing it and pulling it out toward you, as shown in
Figure 33 on page 51.
2. On the console, select the drive that you want to remove and press Enter. To view the locations of the
service indicators, go to "Disk drive locations and service indicators for the 8202-E4B, 8202-E4C,
8202-E4D, 8205-E6B, 8205-E6C, or 8205-E6D system" on page 97.
Important:
v When you press Enter, after your selected time delay, the service indicator light comes on (solid) for
18 seconds. You then have 18 seconds to unlock and remove the drive. You can set an appropriate
time delay of 01 - 19 minutes to allow adequate time to access the disk drive or solid-state drive.
v If you are removing a disk drive or solid-state drive on the 5887 disk drive enclosure the service
indicator is solid (on) and does not flash during this procedure.
3. When the identify LED turns on solid, squeeze and pull the handle of the drive out toward you
before you remove the disk drive or solid-state drive. If the handle is not all the way out, the disk
drive or solid-state drive cannot slide out of the system or out of the expansion unit.
4. Support the bottom of the drive as you slide it out of the system or an expansion unit. Do not hold
the disk drive or solid-state drive by the handle. Press Enter on the console to indicate that you have
removed the drive. The identify LED turns off.
50
Disk drives or solid-state drives