Disk Drive; Removing A Front Disk Drive - IBM 9006-22P Servicing

To Disconnect: 1) Turn off everything (unless instructed otherwise). 2) For AC power, remove the power
cords from the outlets. 3) For racks with a DC power distribution panel (PDP), turn off the circuit
breakers located in the PDP and remove the power from the Customer's DC power source. 4) Remove
the signal cables from the connectors. 5) Remove all cables from the devices.
To Connect: 1) Turn off everything (unless instructed otherwise). 2) Attach all cables to the devices. 3)
Attach the signal cables to the connectors. 4) For AC power, attach the power cords to the outlets. 5)
For racks with a DC power distribution panel (PDP), restore the power from the Customer's DC power
source and turn on the circuit breakers located in the PDP. 6) Turn on the devices.
•
care when handling equipment to avoid cuts, scrapes and pinching. (D005)
Attention:
Failure to follow the step-by-step sequence for part removal or installation might result in part or
system damage.
For safety, airflow purposes and thermal performance, the service access cover must be installed
and fully seated before you power the system on.
For safety and airflow purposes and thermal performance, if you remove parts from the system,
you must ensure that PCIe tail-stock fillers are present.
Use the following precautions whenever you handle electronic components or cables.
• The electrostatic discharge (ESD) kit and the ESD wrist strap must be used when you handle
logic cards, single chip modules (SCM), multichip modules (MCM), electronic boards, and disk
drives.
• Keep all electronic components in the shipping container or envelope until you are ready to
install them.
• If you remove, and then reinstall an electronic component, temporarily place the component on
an ESD pad or blanket.
Removing and replacing a disk drive in the 9006-22P
Learn how to remove and replace a disk drive in the system.
Removing a front disk drive from the 9006-22P system
To remove a front disk drive from the system, complete the steps in this procedure.
Before you begin
You can remove and replace front disk drives with the system powered on and running.
Procedure
1. Attach the electrostatic discharge (ESD) wrist strap.
The ESD wrist strap must be connected to an unpainted metal surface until the service procedure is
completed, and if applicable, until the service access cover is replaced.
Attention:
• Attach an electrostatic discharge (ESD) wrist strap to the front ESD jack, to the rear ESD jack,
or to an unpainted metal surface of your hardware to prevent the electrostatic discharge from
damaging your hardware.
2 Power Systems: Servicing the 9006-22P
Sharp edges, corners and joints may be present in and around the system. Use