Installing And Removing An Internal Dvd-Rom Drive Or Dvd-Rom Blank Bezel - IBM 88371RU Maintenance And Troubleshooting Manual

1. Read Appendix B, "Safety information," on page 129 and "Installation guidelines"
2. Remove the filler panel for the drive from either bay.
3. If you have only one simple swap hard disk drive, you can install it in either the
4. Insert the simple swap hard disk drive into the drive tray assembly.
5. Slide the drive into the bay until the rear of the drive snaps into place with the
6. Install the filler panel for the drive.
7. If you have other options to install, install them now. Otherwise, go to
Installing and removing an internal DVD-ROM drive or DVD-ROM blank
bezel
The following notes describe the type of DVD-ROM drive the server supports and
other information that you must consider when installing a DVD-ROM drive:
v The server supports the installation of an optional DVD-ROM drive only when
v The DVD-ROM drive must be a slim 9.5 mm drive and you install it underneath
If you are removing an internal DVD-ROM drive or blank bezel, continue with
"Removing an internal DVD-ROM drive or DVD-ROM blank bezel" on page 29. If
you are installing an internal DVD-ROM drive or blank bezel, go to "Installing an
internal DVD-ROM drive" on page 31.
Removing an internal DVD-ROM drive or DVD-ROM blank bezel
Complete the following steps to remove an internal DVD-ROM drive or DVD-ROM
blank bezel:
1. Read Appendix B, "Safety information," on page 129 and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect all power cords and
on page 15.
Note: To make sure there is adequate system cooling, do not operate the
server for more than 2 minutes without either a hard disk drive or a filler
panel installed in each bay.
left bay or the right bay.
rear panel-mount connector. This simple swap connector contains the signal
and power connections that are needed by the SATA drive.
"Completing the installation" on page 47.
you are using a 3.5-inch hard disk drive configuration.
the 3.5-inch hard disk drive, on the left side.
Note: DVD-ROM, CD-ROM and diskette drives can also be attached externally
using the USB connector.
on page 15.
external cables (see "Turning off the server" on page 10); then, remove the
cover (see "Removing the cover" on page 18).
Chapter 3. Customer replaceable units
29