Parameter Types - Siemens Sinamics GM150 6SL3835-2LN44-2AA0 Operating And Installation Instructions

8.4.2

Parameter types

Parameter types
The following parameters are available:
● Adjustable parameters (write/read)
● Visualization parameters (read-only)
All these drive parameters can be read and changed via PROFIBUS using the mechanisms
defined in the PROFIdrive profile.
Parameter categories
The parameters for the individual drive objects (DO) are categorized according to data sets as
follows:
● Data-set-independent parameters
● Data-set-dependent parameters
SINAMICS GM150 6SL3835-2LN44-2AA0
Operating Instructions Rev.201910281250 MUSTER
Adjustable parameters directly influence the response of a function, e.g. the ramp-up and
ramp-down time of a ramp-function generator.
Display parameters are used to display internal variables, e.g. the actual motor current.
Figure 8-15 Parameter types
These parameters exist only once per drive object.
These parameters can exist several times for each drive object and are addressed via the
parameter index for reading and writing. The following data set types can be distinguished:
– CDS: Command data set
By parameterizing several command data sets and switching between them, the drive
can be operated with different preconfigured signal sources.
– DDS: Drive data set
The drive data set contains the parameters required for switching the drive control
parameters.
The CDS and DDS data sets can be switched during operation. Further data set types
also exist, however these can only be activated indirectly by means of a DDS
changeover.
– EDS: Encoder data set
– MDS: Motor data set
Operation
8.4 Parameter
143