Siemens Sinamics GM150 6SL3835-2LN44-2AA0 Operating And Installation Instructions page 137

● Mixed operation of servo/vector
● Database mode for the test bay
1. Select the desired setting using the ▼ function key.
2. Change the setting using the <Change> function key.
3. Confirm the setting using the <Back> function key.
Load the AOP settings from the CU
Each time the power supply of the AOP is switched on, the AOP settings are read by the drive.
This makes it possible to swap AOPs without losing the settings.
If you set the selection to "No" in the "Load AOP settings from CU" row, you can transfer the
settings from one drive to the other one.
Automatically acknowledge topology
If the AOP is connected to a drive that has not yet saved a setpoint topology (p99=r98), the
topology is automatically acknowledged by the AOP. If the selection is set to "No" in the
"Automatically acknowledge the topology" row, the automatic acknowledgement of the
topology is disabled.
Mixed operation of servo/vector
This function is not supported.
Database mode for the test bay
If the AOP is connected to a drive unit with a changed topology or changed software version,
the database is deleted and rebuilt. For the special device test application, you can activate the
"Database mode for the test bay" function. This activation can be used, for example, to redefine
a Motor Module as an Active Line Module during the test. The automatic deletion of the
database is disabled.
SINAMICS GM150 6SL3835-2LN44-2AA0
Operating Instructions Rev.201910281250 MUSTER
8.3 Operation via the AOP30 operator panel
Operation
137