Transport With A Crane; Using Lifting Rods - Siemens Sinamics GM150 6SL3835-2LN44-2AA0 Operating And Installation Instructions

Preparations for use
4.3 Transportation
4.3.5

Transport with a crane

Danger due to incorrect transport
If the transport unit is not properly transported with a crane, the transport unit/cabinet could fall
or tip over This can result in death, serious injury or material damage.
● Make sure that you read the safety information about transportation and the information
Danger due to unsuitable cross-arms
If inappropriate cross-arms are used, the transport unit or cabinet can tip over. This can result
in death, serious injury or material damage.
● Observe the specifications provided in DIN EN 13155 on cross-arms.
Observe the following points for safe transport:
● When using a crane to transport the equipment, keep to the permissible lifting capacity. Pay
● If the cabinet center of gravity is off-center, use suitable lifting equipment, e.g. a lifting beam.
● If the cabinet has eye hooks, use them. In such cases, do not use any lifting rods.
4.3.6

Using lifting rods

During transportation with a crane, force is absorbed by the supporting frame of the cabinet.
The supporting frame remains on the unit. The device is mounted at the installation site via the
supporting frame.
Note
Transporting the option cabinet
When transporting an option cabinet, the force is absorbed via the screwed-on U sections.
Remove the U sections after transporting the cabinet.
Please observe the transport information in the option cabinet.
Note
Lifting bars
The lifting bars are not included in the scope of delivery.
66
WARNING
provided on the transport unit (e.g. center of gravity specifications).
WARNING
attention to the center of gravity position.
SINAMICS GM150 6SL3835-2LN44-2AA0
Operating Instructions Rev.201910281250 MUSTER