Table 8-1 List Of Signals For The Operation Screen - Siemens Sinamics GM150 6SL3835-2LN44-2AA0 Operating And Installation Instructions

7. You have two parameter selection options:
8. Select the desired parameter or enter the parameter from the numeric keypad.
9. Confirm the setting by pressing the <OK> function key. The "Please wait" message appears
List of signals for the operation screen
Table 8-1 List of signals for the operation screen
Signal
DO: Vector MV
Factory setting (entry no.)
Speed setpoint upstream of RFG (1)
Output frequency (2)
Output smoothed (3)
DC-link voltage smoothed (4)
Actual speed smoothed (5)
Actual absolute current smoothed (6)
Motor temperature (7)
Motor temperature (8)
Actual torque smoothed (9)
Drive output voltage smoothed (10)
Speed setpoint smoothed
Control factor smoothed
Field-producing current component
Torque-producing current component
SINAMICS GM150 6SL3835-2LN44-2AA0
Operating Instructions Rev.201910281250 MUSTER
– All parameters of the selected DO
Press the <▼> function key to select "All parameters". Then confirm the selection with
OK. A list of all parameters of the selected DO is displayed.
– Selection of plausible parameters (see "List of the signals for the operation screen"
below) of the selected DO.
Select a parameter from the list of the signals for the operation screen of the selected DO.
The selected parameters from this list are displayed in the operation screen with an
abbreviated name (e.g. NSOLL).
briefly. Then the operation screen appears in the configuration you set.
Parameter
r1114
r0024
r0032
r0026
r0021
r0027
r0035
r0037
r0031
r0025
r0020
r0028
r0029
r0030
8.3 Operation via the AOP30 operator panel
Short name Unit
NSETP 1/min
F_OUT Hz
P_ACT kW
UDC V
N_ACT 1/min
I_IST A
T_MOT °C
T_LT °C
M_ACT Nm
C_OUT V
NSETP 1/min
%
A
A
Operation
Scaling
(100% = ...)
p2000
Reference frequen‐
cy
r2004
p2001
p2000
p2002
Reference tempera‐
ture
Reference tempera‐
ture
p2003
p2001
p2000
Reference control
factor
p2002
p2002
115