Siemens Sinamics GM150 6SL3835-2LN44-2AA0 Operating And Installation Instructions page 135

Control settings
In this menu, set the functions that the AOP control keys should perform. For example, you can
specify whether the <OFF> key is associated with the OFF1, OFF2 or OFF3 function.
More detailed information is available in Chapter "Control settings".
Display settings
Make the following AOP settings in this menu:
● Illumination (on, off after 2 minutes, off)
● Intensity of illumination
● Contrast
1. Select the desired setting using the <▼> function key.
2. Change the setting using the <Change> function key.
3. Confirm the setting using the <Back> function key.
Defining the operation screen
In this menu, you can define which parameters the operation screen should display.
A DriveObject (DO) selection is offered on each display. The corresponding parameter list is
offered for each DO. You can select and assign all parameters (r and p). In addition, a selection
of plausible displayable parameters is displayed for each DO.
More detailed information is available in Chapter "Defining operating screens".
SINAMICS GM150 6SL3835-2LN44-2AA0
Operating Instructions Rev.201910281250 MUSTER
8.3 Operation via the AOP30 operator panel
Operation
135