General Information; Parts Replacement - GE 325 Product Manual

SECTION 9
GENERAL INFORMATION
The Corometrics factory makes every effort possible to
provide the most up-to-date reference documentation for your
Corometrics equipment. However, in special cases involving
field-installed upgrades, the revision level of a schematic,
assembly drawing, or parts list in this manual may not reflect
the revision level of your unit. When discrepancies are
found, contact the Corometrics Service Department at one of
the numbers below:
e Inside the United States:
1-800-808-CORO (2676)
* Outside the United States:
(203) 284-2498;
or contact your local distributor
PARTS REPLACEMENT
The Model 325 Simulator employs standard electrical
components and hardware when practical. However, certain
subassemblies may require special components which are
available through Coremetrics. Material contained in this
section is intended for general reference use only and not for
direct ordering of replacement parts. Questions regarding the
suitability or nature of a replacement part should be resolved
with the Corometrics Service Department. To expedite the
clarification process, it is suggested that the following steps
be taken:
1. Obtain the serial number listed on the unit.
2. Note any identification data on the subassembly in
question. Printed circuit boards are identified by a code
printed along one edge of the board.
3. Locate and identify any components in question by
referring to the assembly drawing and the associated
parts list presented in this section.
Finally, call the Corometrics Service Department at one of
the numbers listed above in General Information
9-2 ο Drawings