Lock Installation - Assa Abloy Sargent Profile Series Installation Instructions Manual

Profile Series v.S1 PoE Mortise Lock

Lock Installation

8
1 – Door Preparation
A. Verify Hand and Bevel of Door
Stand on outside of locked door when determining door hand.
LH
Left Hand
Hinges Left
Open Inward
B. Door Preparation
Prior to installation, all holes must be free of burrs, debris and sharp edges.
Prepare door according to appropriate template (see website www.intelligentopenings.com):
• Manufacturer Door Template: 4533
Through-bolt Hole
Ribbon Cable Hole
(Controller to Keypad)
Outside of Cylinder Hole
(only with cylinder installation)
Lever Handle Hole
*Note: Raceway placement in
document is approximate.
LHRB
Left Hand
Reverse Bevel
Hinges Left
Open Outward
Fig. 1A
Outside of Door
Mortised
Pocket
Fig. 1B
RH
Right Hand
Hinges Right
Open Inward
Inside of Door
Pre-drilled and/or
Tapped Holes
1-800-810-WIRE • www.sargentlock.com • A7764D
RHRB
Right Hand
Reverse Bevel
Hinges Right
Open Outward
Through-bolt Hole
*Raceway
Ribbon Cable Hole
(Controller to Keypad)
Inside of Lockbody Wire Hole
(only with cylinder installation)
Thumb Turn Lever Hole
Lever Handle Hole
11