SN200/210 Bored Lock
Installation Instructions
6
1 Door Preparation
A. Verify Hand and Bevel of Door
Stand on outside of locked door when determining door hand.
Left Hand
Hinges Left.
Open Inward.
"LH"
B. Door Preparation
Prepare door according to appropriate template.
If necessary, refer to website: www.intelligentopenings.com.
Instructions show wood door, with cable channel on inside for wires.
For metal door, route wires inside door.
•
Prior to installation, make sure all holes are free of burrs, debris, and sharp edges.
•
If doors are not properly reinforced per ANSI 115.2, commercially available reinforcements
should be installed.
•
Templates:
Door Manufacturer's Template: 4703
•
•
Field Template (supplied with product): A8124
•
Outside Field Prep Template: A8129
Outside of
Door
Raceway for Power
and Access Control
Hole for Reader
and ElectroLynx
cables
Pre-drill Holes
(2 places)
Lock Body Hole
A8282B • 800-810-WIRE (9473) • www.sargentlock.com
Left Hand
Right Hand
Reverse Bevel
Hinges Right.
Hinges Left.
Open Inward.
Open Outward.
"LHRB"
Fig. 1A
Fig. 1B
(Wood Door Shown)
Right Hand
Reverse Bevel
Hinges Right.
"RH"
Open Outward.
"RHRB"
Inside of
Door
Hole for Reader
and ElectroLynx
Pre-drill Holes
(4 places)
Through-bolt Holes
11
Raceway for Power
and Access Control
cables