Assa Abloy Sargent Profile Series Installation Instructions Manual page 16

8 – Escutcheon Wire Connections
Images are shown without gasket. If gasket is necessary,
refer to 5.
Before the controller is attached to the door:
1. Remove the cover from the inside escutcheon by removing the
security screw with the provided tool (Fig. 8A).
2. Attach the reader assembly ribbon cable into the back of the
controller assembly (side that faces towards the door when
mounted (Fig. 8B).
3. Attach the antenna to the circuit board in the plastic housing
under the controller assembly.
Note: The difference between the wiring for the iCLASS 13.56
MHz reader and the 125 kHz Prox is that the iCLASS wiring
includes an antenna wire.
4. Attach the ground wire to the bottom of the controller
assembly (Fig. 8B).
Scan to see a video of this
installation step.
Inside Escutcheon
Connections
Escutcheon
16 1-800-810-WIRE • www.sargentlock.com • A7764D
3
Ground
Wire
Reader
Cable
1
2
Antenna
Outside
(iCLASS)
Profile Series v.S1 PoE Mortise Lock
Ground Ring
Terminal
4-Pin Connectors
From Hinge
Reader
1
Cable
3
2
Antenna
(iCLASS only)
Ground
Wire
Fig. 8B
Tabs
Retaining
Slots
Fig. 8A
Inside
Escutcheon