Table of Contents
Advertisement
8
Lock Installation
1
Verify Hand and Bevel of Door
Illustrations shown are as viewed from the outside or secure side of opening.
2
Door Preparation (Wood Door shown)
Wood Door shown
Outside Face
of Door
Left Hand
Hinges Left.
Open Inward.
"LH"
Prep door according to supplied door marker (FM356)*.
For door manufacturer templates visit www.corbinrusswin.com and
reference template # T31203.
Note: Be sure to verify backset
before marking & drilling door.
Mark door
Locate and mark horizontal center line at
desired height above floor. Fold template over
edge of door, centering on horizontal line.
Mark centers of holes at proper backset.
Mark both sides of the door.
*Lock body is factory set for 1-3/4"
door, but should be verified during
install and adjusted if door is 2".
For more information, see
Cylindrical Lockset CL3300
Series installation instructions
FM533 (07/12)
Fig. 1
Left Hand
Right Hand
Reverse Bevel
Hinges Right.
Hinges Left.
Open Inward.
Open Outward
"RH"
"LHRB"
Fig. 2
12
Copyright © 2016, 2019, 2021, ASSA ABLOY Access and Egress Hardware Group, Inc.
All rights reserved. Reproduction in whole or in part without the express written
permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
IN120 & IN220 Series
Cylindrical Lock
Right Hand
Reverse Bevel
Hinges Right.
Open Outward
"RHRB"
Inside Face
of Door
**optional for hard-powered
Wi-Fi (IN120)
Remote power**
from hinge
Channel for Cat5e
(or higher) cable
from hinge
IN220 only
Advertisement
Table of Contents
