Advertisement
Profile Series v.G1 Mortise Lock
7
Operational Check
For devices with cylinders:
1. Insert key into cylinder and rotate (There should be no friction against lock case, wire
harness or any other obstructions – refer to Section 6, Step 8 if harness friction exists.
2. The key will retract the latch, key should rotate freely
3. If the deadbolt is thrown, the key will retract both the deadbolt and the latch
4. Inside lever retracts latch and deadbolt (if provided)
5. Enter 1234* to unlock outside lever handle and retract latch and deadbolt
(if provided)
6. If lock is prox only (G1-PA) or RF Technology with prox (G1-TA) - refer to keypad
programming instructions (A7716) to program lock using SofLink Plus™ software.
8
Installation of RF Technology Lock
The RF Technology Lock (G1-TU, G1-TA, G1-TP) is installed as described in sections 1-7 with the
following exceptions:
• Installation of the top through-bolt screw
• Removal process for the battery keeper
A. Installation of the top through-bolt screw:
The antenna board must be carefully moved to access the
upper through-bolt screw. Care should be taken to prevent
damage to the antenna retaining tabs during this process.
Press the two tabs away from the antenna board and lift the
board off the mounting posts. Insert the flat head through-bolt
and secure the escutcheon in place. After tightening the top
through-bolt, replace the antenna board by placing it on the
mounting posts and pressing into the retaining tabs.
B. Removal procedure for the Battery Keeper:
To remove the battery keeper, a flat bladed screwdriver or similar tool must be used.
Insert the screwdriver into the slot at the top of the battery keeper, lift up and pull the top of the keeper
away from the batteries.
To install, insert the tabs on the bottom of the keeper into the battery compartment slots and press the
keeper tightly against batteries.
Insert screwdriver tip
and lift up
10
800-810-WIRE (9473) • www.sargentlock.com • A7756A
Mounting
Posts
Tip out
Battery
Keeper
Flathead through-bolt
Antenna
Board
Retaining
Tabs
Controller
Assembly
Keeper tabs
Advertisement
