Operational Check; Installation Of Rf Technology Lock (G1-Tu, G1-Ta, G1-Tp) - Assa Abloy Sargent Profile G1 Series Installation Instructions Manual

Profile Series v.G1 Cylindrical Lock
7

Operational Check

For devices with cylinders:
1. Insert key into cylinder and rotate.
2. The key will retract the latch. Key should rotate freely
3. Inside lever retracts latch and deadbolt (if provided)
4. Enter 1234* to unlock outside lever handle and retract
latch and deadbolt (if provided)
5. I f lock is prox only (G1-PA) or RF Technology with Prox
(G1-TA) - refer to Keypad programming instruction
manual (A7716)
8 Installation of RF Technology Lock
The RF Technology Lock (G1-TU, G1-TA, G1-TP) is installed as described in
sections 1-7 with the following exceptions:
A. Installation of the top through-bolt screw:
The antenna board must be carefully moved to access the upper
through-bolt screw. Care should be taken to prevent damage to
the antenna retaining tabs during this process.
Press the two tabs away from the antenna board and lift the
board off the mounting posts. Insert the flat head through-bolt
and secure the escutcheon in place. After tightening the top
through-bolt, replace the antenna board by placing it on the
mounting posts and pressing into the retaining tabs.
B. Removal procedure for the Battery Keeper:
To remove the battery keeper, a flat bladed screwdriver or similar tool must be used.
Insert the screwdriver into the slot at the top of the battery keeper, lift up and pull the top of the keeper away from
the batteries.
To install, insert the tabs on the bottom of the keeper into the battery compartment slots and press the keeper
tightly against batteries.
Insert screwdriver tip
and lift up
10
800-810-WIRE (9473) • www.sargentlock.com • A7755A
A7755A.indd 10
• Installation of the top through-bolt screw
• Removal process for the battery keeper
Tip out
Battery
keeper
Outside of
door
Mounting
Posts
Keeper tabs
Flathead through-bolt
Antenna
Board
Retaining
Tabs
Controller
Assembly
11/9/18 12:05 PM