Assa Abloy Sargent Profile Series Installation Instructions Manual page 13

Profile Series v.S1 PoE Mortise Lock
3 – Install Lock Body
1. Insert lock body into mortised cutout (Fig. 3A).
2. Harness exits non-cylinder side of hole.
3. Hold lock body loosely in place with (2) lock
body screws (Fig. 3A).
Note: Do not completely tighten screws at this time.
Scan to see a video of this
installation step.
Install Lock Body
4 – Door Options
A. Fire Stop Plate (P/N 52-0033)
Fire-rated doors require a fire stop plate on
the outside of the door (Fig. 4A).
1. Drill (2) 1/8" x 1-1/4" deep holes in the
door if not already present.
Refer to template for fire-stop
prep locations.
2. Attach with flap up and
out using (2) #8 x 1/2"
self-tapping screws for
wood and metal doors.
B. Weather Conduit (52-2847)
Install weather conduit on
exterior doors only (Fig. 4B).
NON FIRE-RATED
1. Carefully insert the weather conduit into the
ribbon cable hole on the inside of the door.
2. Place the O-ring around the weather conduit
on the outside and up against the door (Fig. 4C).
(2) #12-24 x 1/2"
Flat Head Screws
(Metal Doors)
(2) #12 x 1-1/4"
Flat Head Screws
(Metal Doors)
Connectors
From Hinge
Fig. 3A
Outside of Door
Fig. 4A
Ribbon Cable Hole
Fig.4B
1-800-810-WIRE • www.sargentlock.com • A7764D
Ground
Wire
(2) 4-Pin
Inside of Door
Connectors from
mortise lockbody
exit non-cylinder
side
(2) 1/8" Diameter
Holes Required
Fire Stop Plate
(2) #8 Self-Tapping
Screws for Wood
and Metal Doors
Outside of Door
O-Ring
Fig.4C
13