Assa Abloy Sargent Profile Series Installation Instructions Manual page 17

Profile Series v.S1 PoE Mortise Lock
9 – Install Inside Escutcheon
Lock, DPS and raceway wire connections:
1. Connect the cable from the mortise lock
to the bottom of the controller
assembly (Fig. 9A).
2. Connect the AX/DPS connector
to the 2-pin harness.
3. Push the two connectors from the
raceway over the controller assembly,
through the gap between the plastic
controller assembly and the escutcheon,
to the front of the circuit board.
4. Install the two connectors from the
door raceway and position the cable
on the right side of the escutcheon.
(See 6 Installation Wiring for more detail)
Scan to see a video of this
installation step.
Install Inside Escutcheon
5. Gently fold the excess ribbon connector and ground wire
into the top hole, JST connectors and ground wire into
offset middle hole, and mortise and AX/DPS wires into
bottom hole, being careful not to pinch wires (Fig. 9A).
6. Insert (2) #8-32 x 1-1/4" screws through inside escutcheon
and thread into outside escutcheon (Fig. 9B)
Straighten escutcheons and tighten securely.
Fig. 9A
Fig. 9B
1-800-810-WIRE • www.sargentlock.com • A7764D
Inside of Door
17