Assa Abloy Sargent Profile Series Installation Instructions Manual page 12

2 – How to Change Hand of Lockbody
A. Reverse Lock Hand
Red surface of locking piece must face the outside/
locked side of door. To rotate locking piece (Fig. 2A):
1. Position lock body with red surface of locking piece
visible.
2. Insert blade type screwdriver into locking piece slot
to rotate locking piece toward back of lock body.
3. Rotate the locking piece 180° until RED surface is
on opposite side.
Note: Red indicates locked side (outside).
B. Reverse Latch Hand
Beveled surface of latchbolt must face strike (Fig. 2B).
The deadlatch is self adjusting.
To change the hand of the latchbolt:
1. Insert the blade of a slotted screwdriver (>1/4") into
the spade shape slot behind latch.
2. Rotate the screwdriver 90° to push latchbolt out until
back of bolt clears lock case front.
3. Rotate latchbolt 180° until the latchbolt
drops back into the lockbody.
Note: Latch cannot be unscrewed.
12 1-800-810-WIRE • www.sargentlock.com • A7764D
Profile Series v.S1 PoE Mortise Lock
Locking Slide
Red on Locked Side
Fig. 2A
Spade
Shaped
Slot
Right Hand
Lock Shown
Push In
Latchbolt
Deadlatch
Fig. 2B