Assa Abloy Sargent Profile Series Installation Instructions Manual page 6

Frame Harness Installation
A
Supplied by CI
B-Splice
Crimp Connector
RJ45-M
Ceiling
24AWG
Stranded
Wire for
Earth
Ground
inside
15' Frame
Harness
Frame-Side
Harness
Assembly
(15' length)
Cable
B
drain wire
concealed
in shrink
Molex-M
tubing
B PoE Data Hinge
4-pin M 4-pin F
6-pin M
Frame
6 1-800-810-WIRE • www.sargentlock.com • A7764D
Cut end / ceiling-side PoE harness:
Suggested installation of components and wire harness supplied by McKinney:
Do not confuse pair numbers with pin numbers. A pair number is used for
reference only (e.g.: 10Base-T Ethernet uses pairs 2 & 3). The pin numbers
indicate actual physical locations on the plug and jack.
Hinge side of PoE harness:
1. Feed cut end of harness into hole on hinge-side through single access hole.
2. Push one of the connectors back through hole and feed into separate
access hole.
Each of the hinge-side harness connectors should end up threaded through
a different access hole and matched to the same size pin connector from
the door harness:
• 4-pin male Molex connector.
• 6-pin male Molex connector with ground wire.
Drain Wire
6-pin F
PoE Hinge (Patent Pending)
Profile Series v.S1 PoE Mortise Lock
TIA-568-B Standard Wiring
Pair Number
1 White/Blue
2 White/Orange
3 White/Green
4 White/Brown
Hinge-side harness connectors:
• 4-pin male molex connector
• 6-pin male molex connector with ground wire
Lock-side harness connectors:
• Ring terminal
• (2) 4-pin connectors
• 4-pin Molex connector
• 4-pin connector
Wire PIN
White/Blue 5
Blue 4
White/Orange 1
Orange 2
White/Green 3
Green 6
White/Brown 7
Brown 8