Assa Abloy Sargent Profile Series Installation Instructions Manual page 15

Profile Series v.S1 PoE Mortise Lock
7 – Install and Secure Cylinder (Optional)
1. Thread cylinder into lockbody, rotating the cylinder
clockwise (Fig. 7A).
Cylinder should be flush with escutcheon.
Note: The 43 cylinder may be used when installing
this product with or without a gasket.
Note: SARGENT logo must be horizontal and
on the top of the cylinder (Fig. 7B).
2. Secure the cylinder by tightening cylinder clamp
screw located above the deadbolt using #2
Phillips screwdriver (Fig. 7C).
3. Using the key, test cylinder functions:
• 8278 Function: Key retracts latch.
• 8276 Function: Key retracts latch and projects
and retracts deadbolt.
Position cylinder so that the
SARGENT logo is right-side up.
Scan to see a video of this
installation step.
Install and Secure Cylinder
Correct Incorrect
Fig. 7B
Cylinder Clamp Screw
#2 Phillips
Screwdriver
Fig. 7C
1-800-810-WIRE • www.sargentlock.com • A7764D
Outside of Door
Type 43 Cylinder
Key
Fig. 7A
15