Assa Abloy Sargent Profile Series Installation Instructions Manual page 7

Profile Series v.S1 PoE Mortise Lock
Door Harness Installation
C
Order of installation may vary.
Refer to appropriate sections for instructions.
1. Prop door open.
2. Tape the two lock-side 4-pin connectors to the ring terminal.
3. Using the ring terminal, carefully fish the assembly through the
door channel to the lock.
4. Remove tape from ring terminal and door harness connectors.
Hinge-side harness connectors:
• 4-pin male Molex connector
• 6-pin male Molex connector with ground wire
Lock-side harness connectors:
• Ring terminal
• (2) 4-pin connectors:
• 4-pin Molex connector
• 4-pin connector
4-pin F
Drain Wire Cable
26 AWG stranded,
6-pin M
shielded, 100ohm
Inside of Door
C
4-Pin
: CAT 5e,
4-Pin
Molex
Ground
Ring Terminal Secured
to Lock Mounting Plate
1-800-810-WIRE • www.sargentlock.com • A7764D
PoE Lock
D
JST
Ground
Ring Terminal
JST 4-Pin
From Hinge
7