Installation Wiring - Assa Abloy Sargent Profile Series Installation Instructions Manual

Profile Series v.S1 PoE Mortise Lock

Installation Wiring

6
A
PoE frame harness assembly (From McKinney)
B PoE data hinge (Patent Pending) (From McKinney)
C PoE door harness* (From McKinney)
Supplied by CI
B-Splice
Crimp Connector
RJ45-M
Ceiling
24AWG
Stranded
Wire for
Earth
Ground
inside
15' Frame
Harness
Frame-
Side
Harness
Assembly
(15' length)
Cable
drain wire
concealed
Molex-M Molex-F
in shrink
A
tubing
Certified Integrator (CI) supplies and terminates
the B-Splice connector and the
Male RJ45 connector from harness to
end user provided facility cable
Drain Wire
RJ45-F Jack Cable: CAT 5e or higher
24 AWG shielded with drain wire
Cable
: CAT 5e,
26 AWG stranded,
shielded, 100ohm
Molex-F Molex-M
B C
Ring Terminal
Secured to Lock
Mounting Plate
Wiring to TIA-568-B Standard
D DPS: Door Position Switch (cylindrical and exits only)
E
Profile Series v.S1 Online P1 PoE lock
* Order of installation may vary.
Refer to appropriate sections for instructions.
Patch Cable:
Patch Panel to
PoE Switch
E
PoE
Lock
4-Pin
D
4-Pin
Ground
1-800-810-WIRE • www.sargentlock.com • A7764D
Supplied by End User
PoE Switch
Patch Panel
Drain Wire Terminated on Rack
Approved Software
Notes:
• Connectors go on only
one way. They cannot be
positioned incorrectly.
• Do not force and do not
offset connectors.
• Be sure they are seated
properly (flush).
PoE Switch
Terminated to
Earth Ground
5