I -B Locate And Drill Holes For Electronic Components; Section Prepare Lock For Installation - Assa Abloy Yale eBoss 886F Series Installation Instructions Manual

I-B
. Locate and Drill Holes for Electronic Components.
1. Mark door and position templates (Included).
a. Align the template with the 2-1/8" (54mm) hole using the
vertical and horizontal center lines.
b. Mark the remaining hole locations on both sides of the door.
c. Starting with the door face drill ½ way into the door
d Repeat drilling on the back face of the door. .
e. Use the supplied Trim Blank (60-7000-7170) and screws
to cover the cylindrical latch bolt prep (if reqd).
Note: If a metal door is used, ensure it is of good quality
and has the proper reinforcements installed. This
will insure proper lock function.
II
SECTION Prepare Lock for Installation
What is the hand of the door?
Face the door from the outside to determine its hand. The outside is the keypad side of an entrance door or the
corridor side of a room door.
If the lock body is not correct hand, See Section
An ASSA ABLOY Group brand
Left Hand
Reverse:
Hinges on
left, opens
outward. For
handed
locks, specify
LHR.
.
L
C
Right Hand
Reverse:
Hinges on
right, opens
outward. For
handed
locks, specify
RHR.
IIA IIB
or
INSTALLATION
TEMPLATE
L
C
HORIZONTAL
CENTERLINE
TAPE TO DOOR
VERTICAL CENTERLINE
on Page 5
80-8420-0900 Rev. B (05-08)
4