Figure 10-17 Ide Floppy Removal/Replacement; Remove And Replace Peripherals - HP 9000 Series Service Manual

Removal and Replacement Procedures

Remove and Replace Peripherals

This section contains procedures for removing and replacing:
IDE floppy drive
CD-ROM and tape drives
SE SCSI hard disk drives
Remove the IDE Floppy (D Class only)
Refer to Figure 10-17.
1. Remove the power and data (flat ribbon) cables from the rear of the floppy drive.
2. Remove two screws in the front of the chassis, and slide the floppy drive out of the peripheral bay.

Figure 10-17 IDE Floppy Removal/Replacement

10-28 Chapter 10