Table 12-3 Modem Result Codes - HP 9000 Series Service Manual

Modem Result Codes

Table 12-3 Modem Result Codes

Digit Wordw
0 OK
1 CONNECT
2 RING
3 NO CARRIER
4 EEROR
5 CONNECT 1200
6 NO DIAL TONE
7 BUSY
8 NO ANSWER
9 CONNECT 2400
11 CONNECT 4800
12 CONNECT 9600
13 CONNECT 14400
Chapter 12
Command was executed without error, ready for next
command.
Modem has detected carrier and gone on-line.
Modem has detected ring caused by incoming call.
No carrier signal has been detected within the allowed time.
Error in command line (too many, or invalid characters).
Modem has detected carrier at 1200 bps and gone on-line.
No dial tone has been detected.
A busy signal has been detected.
Remote system did not answer.
Modem has detected carrier at 2400 bps and gone on-line.
Modem has detected carrier at 4800 bps and gone on-line.
Modem has detected carrier at 9600 bps and gone on-line.
Modem has detected carrier at 14400 bps and gone on-line.
Remote Management/Access Port Card
Effect
12- 11