Step - HP 9000 Series Service Manual

HotSwap Disk Bay (D Class Only)
OR
# lvreduce -m 1 -A n BB LV name EB /dev/dsk/cXtXdX for 2 way mirroring
For our example:
# lvreduce -m 0 -A n /dev/vg00/lvol4 /dev/dsk/c2t4d0
# lvreduce -m 0 -A n /dev/vg00/lvol5 /dev/dsk/c2t4d0

Step 3

• Replace the faulty disk. Please refer to the appropriate administration guide for
instructions on how to replace the disk.
• Do an ioscan on the replaced disk to insure that it is accessible and also as a double
check that it is a proper replacement (see Note 3 above).
For our example:
# ioscan /dev/dsk/c2t4d0
Step 4
• Restore the LVM configuration/headers onto the replaced disk from your backup of
the LVM configuration:
# vgcfgrestore -n BB volume group name EB /dev/rdsk/cXtXdX
• where X is the Logical unit number of the disk that has been replaced.
For our example:
# vgcfgrestore -n /dev/vg00 /dev/rdsk/c2t4d0
Step 5
• Attach the new disk to the active volume group with the vgchange command.
# vgchange -a y BB volume group name EB
For our example:
# vgchange -a y /dev/vg00
Step 6
• If this disk is not a mirror of a root disk, then skip this step.
• The mkboot command must be run.
For our example:
# mkboot /dev/rdsk/c2t4d0
• After running the mkboot command, do an lvlnboot -R to relink the replaced disk into
the Boot Data Reserved Area of all the Physical Volumes in the Volume Group.
C-14 Appendix C