HP 9000 Series Service Manual page 159

Ostat Code
FLT 7304
FLT 7305
FLT 7306
FLT 7307
FLT 7308
FLT 7401
FLT 7402
FLT 7403
FLT 7404
FLT 7405
FLT 7500
FLT 7501
FLT 7502
FLT 7604
WARN 7701
WARN 7702
WARN 7703
WARN 7704
WARN 7705
WARN 770F
WARN 7800
FLT 7800
WARN 7801
WARN 7802
WARN 7803
WARN 7804
PDCE_HPMC Memory Fault Codes
FLT 7D03
FLT 7D04
Chapter 5
Unknown sizing compare fault
Multi-bit error occurred during sizing
Address test failed on memory bank
ECC test failed on memory bank
Single bit memory error caused HPMC
No memory SIMMs installed
Both EDO and STD memory SIMMs installed
Address did not map to bank
Address did not map to Group Configuration Table
Dual issue test failed
No RAM found
Not enough good memory to run Operating System
Not enough good memory to run Boot Console Handler
No bits set in memory test status
Using alternate memory configuration
Memory not tested, initialized only
SIMM loading warning
RAM bus warning
Good memory required to run Operating System is greater than memory
size
Rev 1 Slave Memory Controller search routine being used
PDT disabled warning
PDT disabled halt
Overwrite single bit error with multi-bit error in Page Deallocation Table
Duplicate Page Deallocation Table entry
EEPROM fault while updating Page Deallocation Table
Page Deallocation Table is full
MSI read time-out (HPMC, caused by accessing beyond the end of memory
or non-responding Slave Memory Controllers)
MSI write time-out (HPMC, caused by accessing beyond the end of memory
or non-responding Slave Memory Controllers)
Dx50/Dx60 Front Panel LCD Codes
Description
5-17