Table 11-25 J2 Jumper Description - HP 9000 Series Service Manual

SCSI Peripherals and I/O Information

Table 11-25 J2 Jumper Description

TE
On
Off
DS
Off Off
Off On
On Off
On On
WP
On
Off
PE
On
Off
SS
Off
11-70
On board non-removable terminator circuits enabled.
Terminator circuits not enabled (Default setting).
ME
Spindle starts immediately after power up (Default
setting).
Drive spindle does not start until Start Unit Command
received from host.
Spindle startup is delayed by SCSI ID times 12 seconds
after power is applied.
Drive spindle starts when Start Unit command is
received from host. Delayed start feature is overridden
when the ME jumper is installed.
Entire drive is Write Protected.
Drive not Write Protected (Default setting).
Parity checking and parity error reporting by the drive is enabled (Default
setting).
Drive does not report results of parity checking to host.
Reserved Jumper position.
Meaning
Meaning
Meaning
Meaning
Meaning
Chapter 11