Removing Existing Bed - Toro 41235 Operator's Manual

Procedure
11
12
14
Note: Determine the left and right sides of the machine
from the normal operating position.
1

Removing Existing Bed

No Parts Required
Procedure
1. Start the engine. Engage the hydraulic lift lever and
lower the bed until cylinders are loose in slots. Release
the lift lever and the turn off engine.
2. Remove the lynch pins from the outer ends of the
cylinder rod clevis pins (Figure 3).
Description
Center boom assembly
Bolt (3/8 x 1-1/4 inches)
Lock nut (3/8 inch)
Boom transport cradle
Bolt (1/2 x 1-1/4 inches)
Flange nut (1/2 inch)
Left boom extension
Right boom extension
Hose clamps
R-clamp
Shoulder bolt
Washer
Nut
Operator's Manual
Operator Training Material
Parts Catalog
Registration Card
Selection guide
Pre-delivery Inspection Sheet
Qty.
1
10
10
2
Install the boom assembly.
4
4
1
1
3
2
2 Install boom hoses.
2
2
1
1
1
Read the manuals and view the training
material before operating the machine.
1
1
1
1. Cylinder rod end
2. Bed mounting plate
3. Clevis pin
3. Remove the clevis pins securing the cylinder rod ends
to the bed mounting plates by pushing the pins toward
the inside (Figure 3).
4. Remove the lynch pins and clevis pins securing the
pivot brackets to the frame channels (Figure 4)
11
Use
Figure 3
4. Lynch pin
5. Rear slots (Full bed)
6. Front slots (2/3 bed)