Table of Contents
Advertisement
Media and Additional Parts
Description
Operator's Manual
Parts Catalog Instruction Card
Screen filter
Note:
Determine the left and right sides of the machine from the normal operating position.
Note:
If you have questions or need additional information regarding the spray control system, refer to the
Operator's Manual supplied with the system.
Important:
This sprayer is sold without spray nozzles.
To use the sprayer, you must obtain and install the nozzles. Contact your authorized Toro distributor for
information on the available section kit and accessories.
After you install your nozzles and before using the sprayer for the first time, adjust the section bypass
valves so that the pressure and application rate remains the same for all sections when you turn 1 or
more sections off. Refer to
Important:
The Multi-Pro WM turf sprayer requires a 4-post ROPS or cab installed with the Workman
vehicle.
1
Removing the Existing Bed
No Parts Required
Procedure
CAUTION
The full bed weighs approximately 95 kg (210
lb). You can injure yourself if you remove the
bed without aid.
• Do not try to install or remove the bed by
yourself.
• Get the help of 2 or 3 other people or use
an overhead crane.
1.
Park the machine on a level surface, engage the
parking brake, and start the engine.
2.
Move the hydraulic lift lever forward and lower
the bed until the clevis pins for the cylinder rod
end lift cylinders are loose in the mounting slots
of the bed mounting plates.
3.
Release the hydraulic lift lever, set the hydraulic
lift lock lever, shut off the engine, and remove
the key; refer to the Operator's Manual of your
machine.
4.
Remove the lynch pins from the outer ends of
the cylinder rod clevis pins
Qty.
1
1
2
Calibrating the Sprayer Flow (page
(Figure
3).
Read the manuals before operating the machine.
53).
1. Cylinder rod end
2. Bed mounting plate
3. Clevis pin
5.
Remove the clevis pins securing the cylinder
rod ends to the bed mounting plates by pushing
the pins toward the centerline of the machine
(Figure
3).
6.
Remove the lynch pins and clevis pins securing
the pivot brackets of the bed to the frame
channels of the machine
11
Use
Figure 3
4. Lynch pin
5. Rear slots (full bed)
6. Front slots (2/3 bed)
(Figure
4).
g002368
Advertisement
Chapters
Table of Contents
